About Hacksaw Blade

HACKSAW

A hacksaw blade is made of - Low alloy steel or high alloy steel.

What is the standard length of hacksaw - 250mm to 300mm

What is the pitch of the blade - the distance between adjacent teeth is known as the pitch .

How many types of pitch of Hacksaw - Coarse 1.8

- Medium 1.4-1.0

- Fine 0.8mm

Type of set ----------------------------------- Pitch

Wave set -- 0.8mm

Wave and Staggered -- 1.0mm

Staggered set -- Over 1.0mm

The selection of the blade depends - On the shape and hardness of the material to be cut .

For Bronze, Brass, Soft steel, Cast iron, Heavy angles used - 1.8mm pitch.

For Tool Steel , High carbon steel , Hss Used - 1.4mm Pitch.

Brass tubing, Cu, iron Pipe Used- 1mm Pitch.

For Thin Tubing, sheet metal Used -- 0.8mm Pitch

Comments

Types of Vices, Bench Vice, Machine Vice, Pipe Vice, Hand Vice, Leg Vice, Pin Vice,Tool Maker Vice.

Vice A bench vice is made of - cast iron or cast steel and it is used to hold work for filing, sawing, threading etc. Parts of a bench vice - Sl. Name of parts Material i Fixed Jaw Grey cast iron ii Movable jaw Grey cast iron iii Jaw plates Tool steel iv Spindle Mild steel v Handle Mild steel vi Box Nut Phosphorous Bronze The size of vice indicated by the – width of the jaw. Vice Clamps or soft jaw is made of – Aluminium. The vice clamps are used to – Protect the finish surfaces of the job. A bench vice is fixed at at a height of – Elbow Position . A bench vice is fixed at at a height of – 106 cm . The bench vice is called as Parallel jaw vice because – It’s...

Types of file part- 2 / Types of file according to Shape / Special files and uses

According to Shape Files are seven types. Their are – sl Name sl Name I Flat File V Square file Ii Hand file Vi Triangular file Iii Half Round file vii Knife edge file iv Round file Flat file These files are of rectangular cross section. The edges along the width of these files are parallel up two-thirds of the length, and then they taper towards the point. The faces are double cut and the edges single cut . These files are used for general purposes work . ...

ISRO PREVIOUS YEAR PAPER, TECHNICIAN-B (FITTER)

ISRO PREVIOUS YEAR PAPER TECHNICIAN-B (FITTER) ISRO SATELLITE CENTER, BENGALURU Held on 20.11.2016 1 . Which is not the part of file – a) Sholder b) Heel c) Ferrul d) Barrel 2 .The file used for filing leather is – a) Single cut file b) Double cut file c) Rasp cut d) Curved cut 3. One micron = a) 0.001 b) 0.0001 c) 0.01 d) 0.00001 4 . What is the point angle of prick punch which is used for making light punch marks - a) 45° b) 100° c) 75° d)30 ° 5. The engineer’s hammer is specified by its – a) Volume b) Length of handle c) Weight d) Material 6. If the strength of material to be drilled is high the drill speed should be – a) High b) Low c) Speed will not depend on strength d) none of these 7. Calculate the spindle RPM for drilling speed of 44 m/min and diameter of drill 20mm – a) 350 b) 1400 c) 500 d) 700 8. What is the coolant used for machining cast iron – a) Soluble oil b) Chemi...

ITI Bangla

Search This Blog