Skip to main content

Try Square

                      Try Square 

The try square is used to Check the squareness. 





The Blade is fixed to the stock at 90 Degree. 


*Try Square is specified by length of the Blade

*The accuracy of Square  square is about 0.002mm per 10 mm length .


* Try Square is made of hardend Steel. 



The try square is used to-

1) Check the squareness of machines 



2) Check the flat Ness. &



3) mark line at 90 Degree.



Labels:

Comments

Post a Comment

Popular posts from this blog

Types of Vices, Bench Vice, Machine Vice, Pipe Vice, Hand Vice, Leg Vice, Pin Vice,Tool Maker Vice.

Vice     A bench vice is made of - cast iron or cast steel and it is used to hold work for filing, sawing, threading   etc.    Parts of a bench vice - Sl. Name of parts Material i Fixed Jaw          Grey cast iron ii Movable jaw Grey cast iron iii Jaw plates Tool steel iv Spindle Mild steel v Handle Mild steel vi Box Nut Phosphorous Bronze   The size of vice indicated by the – width of the jaw. Vice Clamps or soft jaw is made of – Aluminium. The vice clamps are used to – Protect the finish surfaces of the job. A bench vice is fixed at at a height of – Elbow Position . A bench vice is fixed at at a height of – 106 cm . The bench vice is called as Parallel jaw vice because – It’s...
3 comments
Read more

TYPES OF FILE

File is used for removing excess material and they are made of High carbon steel. Files are many types according there Grade, cut and shape. According to Grade - five types of file  Rough file  Bastard file  Second cut file  smooth file and  Dead smooth file  According to cut - four types  Single cut file Double cut file Rasp cut file Curved file According to Shape - seven types  Flat file  Hand file  Round file Half round file  Square file  Triangular file Knife edge file
4 comments
Read more

Types of file part- 2 / Types of file according to Shape / Special files and uses

According to Shape Files are seven types. Their are –   sl Name sl                Name I Flat File V Square file Ii Hand file Vi Triangular file Iii Half Round file vii Knife edge file iv Round file                                                    Flat file   These files are of rectangular cross section. The edges along the width of these files are parallel up two-thirds of the length, and then they taper towards the point. The faces are double cut and the edges single cut . These files are used for general purposes work .               ...
Post a Comment
Read more