Skip to main content

Reamer

 

Reamer





Which Tool is used for enlarging by finishing previously drilled holes to accurate size - Reamer


Which taper shank is used for machine reamer to hold on machine spindle - M.T 


Hand Reamer is used to the ream holes manually using - Tap wrench.


The angle between the edges and the reamer axis is called - hELIX ANGLE.


WHICH REAMER IS USED FOR REAMING MORSE TAPER HOLE - SOCKET.


A Taper pin reamer is made with a taper of - 1 in 50.


Which Flute reamer is suitable for reaming holes with key way grooves - Helical flutes reamer.


 The cutting portion of reamer is made of - H.S.S.


The Shank portion of reamer is made of - Carbon steel 



Labels:

Comments

Post a Comment

Popular posts from this blog

Types of Vices, Bench Vice, Machine Vice, Pipe Vice, Hand Vice, Leg Vice, Pin Vice,Tool Maker Vice.

Vice     A bench vice is made of - cast iron or cast steel and it is used to hold work for filing, sawing, threading   etc.    Parts of a bench vice - Sl. Name of parts Material i Fixed Jaw          Grey cast iron ii Movable jaw Grey cast iron iii Jaw plates Tool steel iv Spindle Mild steel v Handle Mild steel vi Box Nut Phosphorous Bronze   The size of vice indicated by the – width of the jaw. Vice Clamps or soft jaw is made of – Aluminium. The vice clamps are used to – Protect the finish surfaces of the job. A bench vice is fixed at at a height of – Elbow Position . A bench vice is fixed at at a height of – 106 cm . The bench vice is called as Parallel jaw vice because – It’s...
3 comments
Read more

Types of file part- 2 / Types of file according to Shape / Special files and uses

According to Shape Files are seven types. Their are –   sl Name sl                Name I Flat File V Square file Ii Hand file Vi Triangular file Iii Half Round file vii Knife edge file iv Round file                                                    Flat file   These files are of rectangular cross section. The edges along the width of these files are parallel up two-thirds of the length, and then they taper towards the point. The faces are double cut and the edges single cut . These files are used for general purposes work .               ...
Post a Comment
Read more

ISRO PREVIOUS YEAR PAPER, TECHNICIAN-B (FITTER)

ISRO PREVIOUS YEAR PAPER TECHNICIAN-B (FITTER)  ISRO SATELLITE CENTER, BENGALURU Held on 20.11.2016 1 . Which is not the part of file – a) Sholder b) Heel   c) Ferrul   d) Barrel 2 .The file used for filing leather is – a) Single cut file b) Double cut file c) Rasp cut d) Curved cut 3. One micron = a) 0.001 b) 0.0001 c) 0.01 d) 0.00001 4 . What is the point angle of prick punch which is used for making light punch marks   - a)       45° b) 100° c) 75° d)30 ° 5.   The engineer’s hammer is specified by its – a) Volume b) Length of handle c) Weight d) Material 6. If the strength of material to be drilled is high the drill speed should be – a) High b) Low c) Speed will not depend on strength   d) none of these 7. Calculate the spindle RPM for drilling speed of 44 m/min and diameter of drill 20mm – a) 350 b) 1400 c) 500 d) 700 8. What is the coolant used for machining cast iron – a) Soluble oil b) Chemi...
7 comments
Read more