Chisel Short Question for ISRO and DMRC

CHISEL

ISRO, DMRC MAY PUCHE JANE WALA QUESTION

100% EXAM MAY ANE WALA HAY

Chisels are used for removing excess metal . Commonly chisels are five types _ 1) Flat Chisel

2) Cross cut Chisel

3) Half round Chisel

4) Diamond point Chisel

5) Web Chisel

1 . Chisel is made from – High carbon steel or chrome vanadium steel .

2 . What is the other name of cross cut chisel – Cape chisel .

3. Cape / cross cut chisel is used for – cutting key ways , grooves .

4 . Dimond point chisel is used for – The corner .

5. Which chisel is used for separating metals after chain drilling – web / punching chisel .

6 . What is the length of chisel – 100 mm to 200 mm .

7. The correct point cutting angle of the chisel depends – on the

material to be chiped .

8 . What is the rake angle of chisel ?

Ans : Rake angle is the angle between the top face of the cutting point and normal 90° to the work surface at cutting edge.

9 . What is the clearance angle ?

Ans : Clearance angle is the angle between bottom face of the point and the tangent to the work surface

10 . How to work crowning – It is allow the chisel to move freely.

11 . The size of chisel is specified - by the width of the blade, type and the purpose for which it is used .

12 . What is the cutting angle for a diamond point chisel ? Ans : 60°

13 . The body of a flat chisel is usually made in the shape of – Octagonal .

14 . Which chisel is used for cutting Curved / oil grooved – Half round chisel .

***MATERIAL to be cut and there Point angle and Angle of inclination

Comments

Types of Vices, Bench Vice, Machine Vice, Pipe Vice, Hand Vice, Leg Vice, Pin Vice,Tool Maker Vice.

Vice A bench vice is made of - cast iron or cast steel and it is used to hold work for filing, sawing, threading etc. Parts of a bench vice - Sl. Name of parts Material i Fixed Jaw Grey cast iron ii Movable jaw Grey cast iron iii Jaw plates Tool steel iv Spindle Mild steel v Handle Mild steel vi Box Nut Phosphorous Bronze The size of vice indicated by the – width of the jaw. Vice Clamps or soft jaw is made of – Aluminium. The vice clamps are used to – Protect the finish surfaces of the job. A bench vice is fixed at at a height of – Elbow Position . A bench vice is fixed at at a height of – 106 cm . The bench vice is called as Parallel jaw vice because – It’s...

Types of file part- 2 / Types of file according to Shape / Special files and uses

According to Shape Files are seven types. Their are – sl Name sl Name I Flat File V Square file Ii Hand file Vi Triangular file Iii Half Round file vii Knife edge file iv Round file Flat file These files are of rectangular cross section. The edges along the width of these files are parallel up two-thirds of the length, and then they taper towards the point. The faces are double cut and the edges single cut . These files are used for general purposes work . ...

TYPES OF GEAR AND THEIR USES

GEAR Purpose of gears - Gears are used to transmit torque or motion from the driving shaft to the driven shaft 1) To change the direction of rotation. 2) To change the velocity ratio. 3) To get positive drive. Types of gear Gears are many types are below BEVEL GEAR - 1) The teeth are cut parallel to the axis of rotation. 2) Transmit power between two shaft. Uses - in Electric screwdriver, Clock, Washing machine, Motorcycle etc. ADVANTAGES- 1) simple in construction 2) Easy to manufacture DISADVANTAGE- 1) center distance is limited. 2) Noise at high speed. ...

ITI Bangla

Search This Blog